You are ether in boot mode or facing the same problem I did: #2 When the LEDs aren't blinking the application does not start. Your boards LED are on GPIOB, GPIO_PIN_13 and GPIO_PIN_14, as in the example from sarnau. Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you were mentioned. when the two leds are blinking, the application is running, so you are not in the boot loader. if boot0 is set to 0 it does not matter what settings you have on boot1. The jumpers are for the boot mode of the stock boot loader of the stm32.
David I started with the same board as you. On Sat,, 17:43 matlab22, wrote: I'm connected the board to loxlink but not getting too far at the moment, need to try and find a schematic for the board I have which is can then try and find out what LED is what, and that the two jumpers marked 0 and 1 are.
The code to send the packet is really simple.I've not got as far as blinking leds, any ideas what io is allocated to d2 and d3? You can do this by adding this to the mbed_app.json _PACKED ntp_packet_t // Total: 384 bits or 48 bytes. The emWin library requires that you tell emWin about which version of the library. In this project I use three libraries, emWin, the IoT Expert ST7789V library (for the display) and the ntp-client library.
To get a new version you can either “cd mbed-os mbed update mbed-os-5.13.3” or to get the latest “cd mbed-os mbed update master”. For some reason which I don’t totally understand when you run mbed new it gives you a slightly older version of mbed-os. You have two basic choices to get the latest mbed. To run this project requires at least mbed-os-5.13.3. You should start this project by creating a project by running “mbed new NTPDemo” or by using mbed studio to create a new project. Project Setup: Create and Configure Project + Add the Libraries Every way that I know requires me to drag a lot of crap into my PSoC6 which I don’t really want to do. Unfortunately I will not show you a beautiful way to convert UTC to Eastern Time because I don’t actually know what that way would be which is very frustrating.
What time is it? Well that may be a little bit over dramatic ? Actually what I will show you is how to use the CY8CKIT-062S2-43012 development kit to get time from the internet using the Network Time Protocol (NTP), update the PSoC 6 RTC and display it on the CY8CKIT-028-TFT using MBED OS. In this article I will solve one of the great mysteries of human kind. Have you ever wondered about the nature of time? Given the demographics of my readers I am quite sure that all of you have pondered this topic.